Question: Where do you connect RGB fans?

Use RGB Y-Cable to connect the fan and the motherboard. Please use RGB 4-Pin connector to an RGB header, and 4-pin fan connector to a fan header on the motherboard.

Where does RGB plug into motherboard?

The motherboard layout index lists two RGB headers, labelled RGB_HEADER1 and RGB_HEADER2. One is on the top edge of the board near the power connector, while the other is on the bottom edge between the front panel audio and serial port headers.

How do I control RGB fans on my PC?

To do this, remove the rear side panel from your chassis and locate the RGB/Fan controller. On the top side of the controller there is a switch, flip it (On the TURBO this controller is in the rear near the power extension cable). RGB in the system should now respond to the remote.

Can you connect a 3-pin rgb to 4-pin?

You can plug a 3pin into a 4pin header for Fans but not ARGB You can’t. 3-pin ARGB headers are 5V with a 5V pin, a single data pin, a blank spot and a ground pin. 4-pin RGB headers are 12V with 12V, red, blue and green pins. Plugging an ARGB strip into a non-ARGB header will blow out the strip.

IT IS IMPORTANT:  How do I view SVG images?

How does rgb fan work?

Basically each fan has two cables, one cable goes to the fan header on the motherboard like normal (or to a fan controller in this case). And the second cable goes to an rgb controller (which these corsair fans come with).

Can I plug rgb into fan header?

Yes they will work as fans even if you plug in it without the rgb part. Most of the rgb fans come with a controller or demand a controller to be plugged in so you can control them via some kind of a software.

Can I use rgb fans without rgb header?

Hi, Yes they will work as fans even if you plug in it without the rgb part. Most of the rgb fans come with a controller or demand a controller to be plugged in so you can control them via some kind of a software.

Can you control RGB fans with motherboard?

No, not all RGB fans can be controlled by the motherboard, and, even among those that can, there are two similar, but incompatible standards. First, to those that cannot be controlled by the motherboard. A lot of cheaper RGB fan kits use proprietary connectors and their own controllers.

How do you connect fans to iCUE?

To configure a fan profile:

  1. Open iCUE.
  2. Select your cooler or fan controller in the DEVICES section.
  3. Click the PERFORMANCE tab on the left side of the screen.
  4. Select a cooling mode, and then click on a device in the preview window to assign the cooling mode.